Published at Tuesday, 28 August 2018. Ottoman Chair. By Inez Sheppard.
This chair design allows for a storage compartment under the seat. The bottom can be made from a lightweight panel and cut to fit the opening perfectly. I chose to attach it with metal L brackets, rather than first strips to maximize the storage space rather than drilling a thumb-sized hole to use to lift the seat to access the storage, I decided to use a screw and a simple loop of twine as a quick pull if I change my mind in the future, I can always add a hole later. I hear it is significantly harder to remove a hole. The spacing in between the slats leaves the storage open for all sorts of creepy crawlers.
Today I'm going to go over how to make a sectional patio chair for this project. I use dimension pine boards, which were 1 by 4 and 1 by 5. To start out, I cut all pieces to length from the pine boards on the radial arm saw to make repeated cuts. I use a stop block. I then ripped the 1 by fours to 3 inches wide on the table saw the off cuts will be useful later.
They can be covered up easily with quarter inch plywood or the off cuts from ripping earlier. After cutting my off cuts to size, I secured them with brad nails. The last step before finishing is to plug the screws. I do this quickly with glue and a dowel.
Any content, trademark’s, or other material that might be found on the hollywoodstandups.com website that is not hollywoodstandups.com’s property remains the copyright of its respective owner/s. In no way does hollywoodstandups.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 hollywoodstandups.com. All Rights Reserved.