Published at Tuesday, 28 August 2018. Ottoman Chair. By Inez Sheppard.
So I set them aside for now. In total I have 2 rear legs, 2 front legs, 6 long, slats and nine short slats. The slots around the chair base will be mitered at 45 degrees on their ends. With my miter gauge and a fence mounted stop block. I made a cut that had a fair amount of tear out to reduce, tear out and mounted a miter gauge fence to support the work piece as it is cut.
A speed square is a handy tool to hold these pieces perpendicular to each other drive a single screw through a leg into the first slot, then recheck for square before driving a second screw and subsequently attach each slat to each leg, because these screws will be in The interior that will not require plugging the shorter front and back slats will be screwed. In from the exterior, I made a guide from an off cut to ensure a consistent spacing for the screws. I also countersunk each hole to recess the screws so that they can be plugged. The short slats will be attached by flushing its mite, together with the long slat and driving one screw in a leg. Slat will do the second screw later.At this point, it would have been nice to have a third hand, as I connect the two sides, together with one screw in each slat. With the chair, standing, plumb and level. The rest of the screws can be driven in. The last three slats are for the backrest. I Drive one screw into the top slot and verify it is horizontal before adding the rest of the screws.
They can be covered up easily with quarter inch plywood or the off cuts from ripping earlier. After cutting my off cuts to size, I secured them with brad nails. The last step before finishing is to plug the screws. I do this quickly with glue and a dowel.
Any content, trademark’s, or other material that might be found on the hollywoodstandups.com website that is not hollywoodstandups.com’s property remains the copyright of its respective owner/s. In no way does hollywoodstandups.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 hollywoodstandups.com. All Rights Reserved.