Published at Tuesday, 28 August 2018. Ottoman Chair. By Inez Sheppard.
Today I'm going to go over how to make a sectional patio chair for this project. I use dimension pine boards, which were 1 by 4 and 1 by 5. To start out, I cut all pieces to length from the pine boards on the radial arm saw to make repeated cuts. I use a stop block. I then ripped the 1 by fours to 3 inches wide on the table saw the off cuts will be useful later.
In that slot. I realize I should have used the speed square for this, but the torpedo level ended up working. Just fine to use the level for this, you need to make sure your project is sitting squarely upon a level surface. The seat will be made of half-inch plywood, with cutouts for the backrest it'll, be supported by the front legs and by 1 by 2. First strips I recess the strips half an inch from the edge to account for the seat and tacked them in with the brad nailed to verify their mounting location when everything checks out, they can be fastened with screws.
So I set them aside for now. In total I have 2 rear legs, 2 front legs, 6 long, slats and nine short slats. The slots around the chair base will be mitered at 45 degrees on their ends. With my miter gauge and a fence mounted stop block. I made a cut that had a fair amount of tear out to reduce, tear out and mounted a miter gauge fence to support the work piece as it is cut.
Any content, trademark’s, or other material that might be found on the hollywoodstandups.com website that is not hollywoodstandups.com’s property remains the copyright of its respective owner/s. In no way does hollywoodstandups.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 hollywoodstandups.com. All Rights Reserved.