Published at Tuesday, 28 August 2018. Ottoman Table. By Gabrielle Rivers.
These will form a support piece on the back and a recess on the front. Cutting out the waste. Chauffeuring, all the edges. Gluing on two of the slats to seat the sides. Correctly.Ready for assembly Gluing in the side pieces first. The slats previously glued on register the side pieces, correctly. Gluing in the slats. I use a spacer that evenly spaces the slats in the remaining recess. Gluing on the front panel.
Planing down to thickness. Cutting strips to final width.. These will become the slats in the center of the tray. Squaring up another piece of walnut for the sides of the tray. Cross, cutting to correct width..
Some scrap cardboard., Roughly tracing out the contour of the tub., Transferring the curves to the front and back panels. Cutting out the waste. Placing side piece into position above the dado., Transferring the offset curve to the side, pieces. A very tall resew on the handsaw. Here we go Phew, Not too bad, Adding some cutouts to the front and back panels..
Evening out the curves., Finding the proper places for a hole that takes into account the tub side, which the tray will be resting on, Hogging out a hole With a Forster bit. Cutting a channel to the hole. Rounding out the hole., This will allow a wine glass to sit without wobbling.
Any content, trademark’s, or other material that might be found on the hollywoodstandups.com website that is not hollywoodstandups.com’s property remains the copyright of its respective owner/s. In no way does hollywoodstandups.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 hollywoodstandups.com. All Rights Reserved.