Published at Tuesday, 28 August 2018. Ottoman Table. By Inez Sheppard.
And it was cheaper than the piece of plywood. My husband used his keg jig to connect the three pieces together and make sure that they were nice and sturdy and they would not flex at all. By doing this, we also purchased the legs and all the other hardware from loads . We decided on how far in we wanted the legs to go. So then we measured where we would place the leg brackets so that we would be certain to place them evenly all the way around, and then we attached the leg brackets.
He was attempting here to secure it and we found out that his a brace here wasn't quite big enough so and it was ok that his clamp didn't quite fit because we had already planned to also use the keg on that. So it would be pretty secure. So it's being cranked and glued and it will hold up pretty securely. So here we're just installing it and we've already um had the holes put in with the Craig, so he can screw it into the top part, and the glue is also going to help it to stay secure and on a little side note if you're going to Want your legs close to the edge and, if you're, going to use these leg clamps, what I would suggest is, before you put your side pieces on and secure those two put your legs in and be certain that you can actually turn them in the event that You would ever want to remove your legs just to be sure that it's not too close to the sides so with the glue and the Craig you're sure to get a nice tight bite and these pieces aren't going anywhere. So my husband decided that he wanted to go ahead and even though everything is nice and tight and secure, he wanted to add a finish nail here.
Once we have the leg brackets in place. We just then marked in the areas where they're going to be screwed and we just put a little dot there so that if, by any chance, the bracket moved prior to getting it installed, we'd know where it was supposed to be laid, because we already had the Holes there marked and then we just simply attached each leg bracket and moved on to the next one until complete and here's the last leg bracket being installed. And after this we will be installing the sides or I guess you could call it. Maybe the skirting of the Ottoman - these are the 1 by sixes that my husband has already cut to size. We just added a little glue to them and attach them.
Any content, trademark’s, or other material that might be found on the hollywoodstandups.com website that is not hollywoodstandups.com’s property remains the copyright of its respective owner/s. In no way does hollywoodstandups.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 hollywoodstandups.com. All Rights Reserved.