Published at Tuesday, 28 August 2018. Ottoman Table. By Inez Sheppard.
He was attempting here to secure it and we found out that his a brace here wasn't quite big enough so and it was ok that his clamp didn't quite fit because we had already planned to also use the keg on that. So it would be pretty secure. So it's being cranked and glued and it will hold up pretty securely. So here we're just installing it and we've already um had the holes put in with the Craig, so he can screw it into the top part, and the glue is also going to help it to stay secure and on a little side note if you're going to Want your legs close to the edge and, if you're, going to use these leg clamps, what I would suggest is, before you put your side pieces on and secure those two put your legs in and be certain that you can actually turn them in the event that You would ever want to remove your legs just to be sure that it's not too close to the sides so with the glue and the Craig you're sure to get a nice tight bite and these pieces aren't going anywhere. So my husband decided that he wanted to go ahead and even though everything is nice and tight and secure, he wanted to add a finish nail here.
We laid that out on the floor and moved around it just to be certain that it wouldn't be too big and that it would also be big enough. The length of that original Ottoman was four feet and I knew that I liked that length because it pretty much covered the majority of the sofa. I initially thought I wanted a square shaped ottoman, but this would have been too much in this small space. So we headed out to Lowe's and we purchased three composite pres composite shelving boards and we also purchased one or two one by six studs to go around the sides. I decided to go with the three pieces of composite shelving as opposed to just a piece of plywood, because the three pieces of pressed wood together came out to exactly the size that I wanted without having to be cut or altered in any way.
And it was cheaper than the piece of plywood. My husband used his keg jig to connect the three pieces together and make sure that they were nice and sturdy and they would not flex at all. By doing this, we also purchased the legs and all the other hardware from loads . We decided on how far in we wanted the legs to go. So then we measured where we would place the leg brackets so that we would be certain to place them evenly all the way around, and then we attached the leg brackets.
Any content, trademark’s, or other material that might be found on the hollywoodstandups.com website that is not hollywoodstandups.com’s property remains the copyright of its respective owner/s. In no way does hollywoodstandups.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 hollywoodstandups.com. All Rights Reserved.